[Nov-2021] DES-DD33 Braindumps – DES-DD33 Questions to Get Better Grades
DES-DD33 Exam Dumps - Try Best DES-DD33 Exam Questions - Prep4away
NEW QUESTION 26
An administrator monitors the performance statistics of a PowerProtect DD appliance. Low disk-write rates are shown, and the network inbound traffic is high.
What is the most likely cause of this behavior?
- A. Known segments
- B. Disk failure
- C. Expired segments
- D. NVRAM failure
Answer: A
NEW QUESTION 27
Which component of PowerProtect DD is Data Invulnerability Architecture a feature of?
- A. CIFS
- B. DD Boost
- C. VTL
- D. DDOS
Answer: D
Explanation:
The Data Invulnerability Architecture is built into DDOS and DD series to provide the industry's best defense against data loss.
NEW QUESTION 28
Which PowerProtect DD procedure uses the DoD/NIST standards to provide data security?
- A. Replication Encryption
- B. Encryption
- C. End-to-End Verification
- D. Data Sanitization
Answer: D
NEW QUESTION 29
What is a requirement to configure the PowerProtect DD tape out to cloud feature?
- A. Two cloud units
- B. DDVE in the Cloud
- C. Tape Out to Cloud License
- D. Cloud Tier Capacity License
Answer: D
NEW QUESTION 30
Following best practices for a PowerProtect DD CIFS environment, what is the recommended SESSTIMEOUT value in seconds?
- A. 0
- B. 1
- C. 2
- D. 3
Answer: D
Explanation:
SESSTIMEOUT value from the default 45 seconds to 3600 seconds.
NEW QUESTION 31
An administrator wants to integrate a PowerProtect DD appliance into their current backup environment using CIFS, NFS, DD Boost, and VTL.
Which backup applications support these protocols?
- A. IBM Spectrum Protect and Veritas NetBackup
- B. Veritas NetBackup and Dell EMC NetWorker
- C. Dell EMC Avamar and Dell EMC NetWorker
- D. Commvault Simpana and Veritas Backup Exec
Answer: B
NEW QUESTION 32
A PowerProtect DD appliance has been installed at a company's location for several months and has reached a steady state.
As a best practice, at what percentage of disk utilization should action be taken?
- A. 80%
- B. 95%
- C. 70%
- D. 60%
Answer: A
NEW QUESTION 33
A PowerProtect DD system is configured for VTL. The backup application requires a minimum tape capacity of 800 GiB.
What is the minimum tape type to support this requirement?
- A. LTO-2
- B. LTO-5
- C. LTO-4
- D. LTO-3
Answer: C
NEW QUESTION 34
What is a characteristic of using replication with Dell EMC Cloud Tier?
- A. Always takes place between the source and destination cloud tier
- B. Cloud Tier is required to be configured on the source and destination systems
- C. Does not require that a file be recalled from the cloud on the source
- D. Always takes place between the source and destination active tier
Answer: D
NEW QUESTION 35
Following best practices for a PowerProtect DD NFS environment, what is the recommended value for rsize and wsize?
- A. 0
- B. 1
- C. 2
- D. 3
Answer: A
NEW QUESTION 36
What are some possible network bottlenecks for a PowerProtect DD?
- A. Connectivity, firewalls, and routing protocols
- B. Routing protocols, switches and routers, and wire speeds
- C. Configuration, wire speeds, switches and routers
- D. Connectivity, routing protocols, and configuration
Answer: C
NEW QUESTION 37
Where can daily information on system and MTree capacity be found?
- A. DDSM Health Overview
- B. Autosupport report
- C. Support Bundle
- D. Message log
Answer: B
NEW QUESTION 38
A Spectrum Protect administrator is configuring VTL on PowerProtect DD.
Which tape driver type should they select?
- A. L180
- B. L6000
- C. L2000
- D. TS3500
Answer: D
NEW QUESTION 39
What information does the daily Autosupport report contain?
- A. MTree capacity and System alerts
- B. Quota alerts and MTree capacity
- C. System and Quota alerts
- D. System and MTree capacity
Answer: C
Explanation:
The autosupport command manages system reports. Command options enable administrative users to manage two reports that describe the state of a Data Domain system: the autosupport report and the daily alert summary.
NEW QUESTION 40
A backup administrator is tasked with monitoring PowerProtect DD capacity metrics. The administrator is backing up 2 TB of data daily with a reduction rate at 5x. After data reduction, subsequent full backups compress down to 100 GB.
The initial backup requires 400 GB with a 10 percent increase in the data each day. Each incremental backup is 200 GB. After data reduction, each incremental backup is 20 GB.
What is the weekly burn rate (GB) after six daily incremental backups and one weekly backup?
- A. 0
- B. 1
- C. 2
- D. 3
Answer: B
NEW QUESTION 41
A backup administrator has enabled the Retention Lock feature on their PowerProtect DD appliance. Over time, the administrator noticed an increase in file system utilization. Upon further investigation, the administrator discovered expired files are still present on the appliance.
What is the most likely reason for this issue?
- A. Retention Lock feature was disabled before the expiration date
- B. Backup application failed to delete the file after expiration
- C. The atime of the file was set below the minimum retention period
- D. File system cleaning was disabled
Answer: B
NEW QUESTION 42
A backup administrator wants to verify that quotas have been enabled on a PowerProtect DD appliance.
Which command is used to verify that quotas are being enforced?
- A. quota capacity status
- B. quota capacity reset
- C. mtree show quota
- D. quota capacity set
Answer: D
NEW QUESTION 43
What happens to the data when it is moved from the active tier to cloud tier?
- A. It is deduplicated and stored in a file system in the native format
- B. It is compressed and stored as object storage in a new format
- C. It is deduplicated and stored in object storage in the native format
- D. It is compressed and stored in block storage in a new format
Answer: A
Explanation:
Every file has a meta-data. Meta-data of the files which is getting moved is stored on active tier and data and metadata is moved into the cloud. There is no multiple data-movement policy set on single mtree. Data moved to particular cloud unit depends on datamovement policy. And only the unique data is sent to the cloud. This is done using the deduplication.
NEW QUESTION 44
How many hops should the fabric configuration be limited to when implementing the DD VTL?
- A. 4 hops
- B. 2 hops
- C. 1 hop
- D. 3 hops
Answer: B
NEW QUESTION 45
What is the maximum capacity that a cloud unit can have with DD9900?
- A. 1,536 TB
- B. 64 TB
- C. 2,016 TB
- D. 576 TB
Answer: D
NEW QUESTION 46
......
EMC DES-DD33 Exam Syllabus Topics:
| Topic | Details |
|---|---|
| Topic 1 |
|
| Topic 2 |
|
| Topic 3 |
|
| Topic 4 |
|
| Topic 5 |
|
| Topic 6 |
|
| Topic 7 |
|
| Topic 8 |
|
| Topic 9 |
|
Verified DES-DD33 exam dumps Q&As with Correct 55 Questions and Answers: https://certblaster.prep4away.com/EMC-certification/braindumps.DES-DD33.ete.file.html